Electrician - Questions & Answers

The cost of placing a fuse box can vary depending on several factors including the location, complexity of the installation, the materials used, and any necessary permits or inspections. On average, the cost of installing a fuse box can range from $500 to $3,000. It is recommended to contact a licensed electrician for a more accurate estimate based on your specific requirements....Read More

If the circuit breaker keeps popping out on a water heater, it usually indicates an electrical issue or overload. Here are a few possible causes and solutions:

1. Overloaded circuit: If the water heater is on a circuit shared with other high-power appliances, it may be causing an overload. Try unplugging other devices connected to the same circuit and see if the breaker still trips. If not, it's best to have a dedicated circuit for the water heater installed.

2. Faulty heating element: If the breaker trips immediately after turning on the heater, it could be due to a faulty heating element. A damaged or short-circuited element can cause excessive electrical current, triggering the breaker. In this case, the heating element may need to be replaced.

3. Wiring issues: Loose or damaged wiring can cause a short circuit and trip the breaker. Check the wiring connections in the water heater and ensure they are secure and undamaged. If any wires are frayed or exposed, they should be repaired or replaced.

4. Overheating thermostat: A malfunctioning thermostat can cause the water heater to exceed the desired temperature and overheat. This can result in the circuit breaker tripping to prevent further damage. Consider replacing the thermostat if it is not functioning correctly.

If you are not comfortable troubleshooting or working with electricity, it is advisable to contact a professional electrician or a water heater service technician to diagnose and resolve the issue.

...Read More

It is advisable to turn off the power to the affected light fixture and nearby outlets to avoid the risk of electrical shock. You should contact a licensed electrician to properly assess and repair any damage that may have been caused by the water leakage. It is important to address any electrical issues as soon as possible to prevent further damage and ensure safety in your home....Read More

The first step would be to turn off power to the affected circuit at the circuit breaker panel. Then, inspect the switches and wiring for any visible damage or signs of burning. Replace any damaged components as necessary. If the issue persists, check the electrical connections in the circuit box and look for any loose or damaged wires. If you are unsure of what to do, it would be best to contact a licensed electrician to troubleshoot the issue safely....Read More

There could be a few potential causes for this issue in a double wide Fleetwood mobile home built in the 90s:

1. Tripped circuit breaker: Even if you've checked the breaker box, it's possible that the circuit breaker for this particular part of the house is a separate one that has tripped. Try flipping all of the breakers off and then on again to see if this solves the problem.
2. Faulty wiring: It's possible that there is a problem with the wiring in the affected area of the house. This could be caused by a number of things, such as rodents chewing on wires or aging wires that have deteriorated over time.
3. Faulty GFCI: While you've checked the GFCIs, it's possible that there is a problem with one of them that you haven't noticed. Try replacing any GFCIs that are supplying power to the affected area as a troubleshooting step.
4. Blown fuse: If your home is equipped with fuses instead of circuit breakers, it's possible that one of them has blown and needs to be replaced.
5. Electrical load: Finally, it's possible that the electrical load in the affected area is simply too high, and you're experiencing a brownout. Try unplugging appliances or devices in the area and see if this solves the problem.

...Read More